SERVO 35 / 35 S models  

• SERVO 35 PLUS / SERVO 35 S PLUS with hydraulic furrow width adjustment.
• SERVO 35 NOVA / SERVO 35 S NOVA with hydro-mechanical stone protection.
• SERVO 35 PLUS NOVA / SERVO 35 S PLUS NOVA with hydraulic furrow width adjustment and hydro-mechanical stone protection.

Body holder

The tempered leg mounting brackets have a large clamping surface to resist high stress. The bracket surrounds the plough beam with a large area of contact for optimum transfer of forces to the beam.

Solid leg mounting on two sides.

• Double-sided shear protection via shear bolts.
• Five furrow widths easily selected via hole matrix by moving a bolt

Headstock

• Double acting reversing cylinder with check valve; hoses are not under pressure during ploughing.
• The full-length mounting axle can be adjusted to four positions and has an anti-twist lock. The correct position on the tractor and optimum clearance at all times.

Three top link positions are possible. Including a slotted hole for faster penetration and lower linkage control. The extra-thick top link retention plate is hardened and guarantees a snug fit for the top link pin

Reversing unit and turnover shaft

The turnover shaft on the SERVO 35 is 100 mm in diameter; on the SERVO 35 S it is 110 mm. The reversing unit made from tempered cast steel is not welded to the turnover shaft. The hydraulic hoses pass through the hollow shaft preventing trapping of the hoses during reversing. The heavy-duty tapered roller bearings are reliably protected from dirt and locked with an adjustable castellated nut. The beam angle is adjusted using two turnbuckles.